Mastering The New Design Rules Of Slime Dryer To Help The Equipment Run Efficiently
In traditional sense, installation and design of coal drier only need to follow the correct operation steps, but with the continuous improvement of user requirements, these can not satisfy users' needs. At present, a new regulation for the design of coal drier system has been introduced, which is quite different from the previous regulations. It seems beneficial to grasp the new rules for the installation design of coal drier system, which can help the equipment run efficiently.
We must check the standby equipment to be installed in place, to be installed in the installation of slime drying machine, so as to not appear other problems in the installation, use in the future will not be because of the errors caused by the initial installation maintenance inconvenience and so on. The installation mainly inspects the quality and size position deviation of the basic concrete pouring: the appearance requires that the foundation surface is clean, no oil stain, dust and sundries, no steel bar is exposed, no crack and corner, there is no residual hull plate in the remaining hole, and other casting defects. The deviation of the base size and position should be in accordance with the following requirements: the shape size and the basic coordinate position, the vertical and horizontal axis error is less than 20mm. The elevation error of different planes is less than 20mm, only negative and negative is allowed. The total error of the slope error is less than 20mm, and the discharge end is allowed to not be positive. The planarity of the upper plane is less than 5mm/m, and the total length is less than 10mm. The equipment is checked and checked, the packing list is checked, the parts, components, standard parts, and random files are counted, and the status of missing parts, deformation and damage is checked, and records are made for purchase or preparation before installation. The protective coating, dust, oil pollution, rust and so on in the packing are cleared, and the damage and deformation caused by the dressing during the loading and unloading process are checked. Pre test and pre install to spare parts and key parts to avoid rework in installation work and ensure installation progress and installation quality.
The new regulations for the installation and design of coal drier are mainly related to many details, as well as some technical problems, which help to improve the efficiency of the equipment. Only when we avoid unexpected failures in the operation of the equipment, can we improve all the details and think of what others have not thought of, and do what others have not done to meet the needs of users, which will play an important role in the industry.